Connects bracket and threaded rod to Slimduct PD at notch points for added support and a clean, professional finish.
The Slimduct PDK Reinforcement for Notch is a critical accessory designed to securely connect a bracket and threaded rod to the Slimduct PD system. It provides proper structural support at the notch point while maintaining a clean, professional appearance for commercial lineset protection.
This fitting can be used with the PDB-N mounting coupler. It also can be used for PVC piping band; however the outer diameter must be smaller than the steel piping. Cannot be used for PDY.
| Code No. | Item No. | Applicable Duct | Applicable piping band (For steel pipe*) | Pcs/Pkg |
|---|---|---|---|---|
| C 68562 | PKD-1 | PD-90 | 2″ or less | 100 |
| C 68562 | PKD-1 | PD-120 | 3-1/4″ or less | 100 |
| C 68562 | PKD-1 | PD-140 | 4″ or less | 100 |
| * Also can be used for PVC piping band; however, the outer diameter must be smaller than the steel piping. | ||||
| * Cannot be used for PDY. | ||||
A. Slimduct PD is a lineset cover system designed to provide a durable and aesthetic solution for protecting HVAC refrigerant piping, wiring, and drain lines in commercial installations.
A. No, Slimduct PD is not waterproof. Caulking or sealing with putty is required at wall penetrations and connection points to prevent water intrusion.
A. The recommended surface temperature range is -20°C to 60°C (-4°F to 140°F). Avoid exposure to extreme heat, especially in confined or sun-exposed spaces, to prevent deformation.
A. Installation in areas with high radiant heat—such as metallic eaves, heat storage walls, or near heat-generating equipment—should be avoided unless well-ventilated, as this can cause material softening or warping.
A. Slimduct PD is available in PD-90, PD-120, and PD-140, corresponding to pipe clamp sizes up to 80A, 100A, and 125A respectively. Each size accommodates different copper pipe combinations with various insulation thicknesses.
A. Vertical piping_1500 mm (59″)
Horizontal piping_1000–1500 mm (39″–59″), depending on support type
Suspension piping_1000 mm (39″)
A. The system includes fittings such as elbows, T-branches, reducers, couplers, wall flanges, reinforcement accessories, and mounting couplers for U-clamps. Each accessory has specific installation procedures and configurations.
A. Slimduct PD is made of durable resin engineered for weather resistance and structural stability, with specific design features to minimize damage under environmental stress.
A. Always wear protective gear, including gloves, goggles, and helmets. Avoid using impact drivers on uneven surfaces to prevent product damage—use torque screwdrivers where possible.
A. Yes, Ducts can be trimmed using a hand saw or hacksaw. Refer to the installation manual for exact cutting lengths based on bracket spacing and pipe clamp widths.
The Slimduct PSPC Protective Cover shields the sides of the cutoff wall plate, enhancing durability...
Protective cover for VRV/VRF branching couplers. Durable and weather-resistant. Fits seamlessly with Slimduct PD system.
Durable cover for commercial rooftop linesets. Clean finish for HVAC or plumbing use. Compatible with...
Secures Slimduct PD ducts to a strut or bracket for stable, clean commercial HVAC installations.
© 2025 Inaba Denko
